Aerco SmartPlate User Manual download pdf (Page 78)

SmartPlate Installation, Operation & Maintenance Manual

CHAPTER 8 – CORRECTIVE MAINTENANCE

Page 78 of 138 AERCO International, Inc.  100 Oritani Dr.  Blauvelt, NY 10913 OMM-0069_0E

PRI: 11/26/2013 Phone: 800-526-0288 SP-100

WARNING

THE DOUBLE-WALL HEAT EXCHANGER CAN WEIGH UP TO

850 POUNDS, DEPENDING ON THE SMARTPLATE MODEL

SIZE. THEREFORE, USE EXTREME CARE WHEN REMOVING

IT FROM ITS MOUNT. A SUITABLE SLING MUST BE USED TO

LIFT AND REMOVE THE HEAT EXCHANGER FROM ITS

MOUNT.

10. Insert a sling through the four (4) holes in the frame plate and pressure plate, as shown in

Figure 8-19, to safely lift the Heat Exchanger off its mount.

Figure 8-19. Heat Exchanger Lifting Sling

11. To replace the Heat Exchanger with a new assembly, simply reverse the previous steps.

Support the replacement Heat Exchanger using a sling as shown in Figure 8-19 and lower

into position on the Heat Exchanger Mount. Ensure it is properly aligned with the Piping

Assembly and Heat Exchanger Mount. Ensure that the bolts on all four Victaulic

couplings are securely tightened. If the unit is a SPDW61 or SPDW113, re-install the rear

support bracket and verify that adjustable legs are properly positioned.

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 137 138

No comments

Aerco SmartPlate User Manual Page 78