Aerco SmartPlate User Manual download pdf (Page 12)

SmartPlate Installation, Operation & Maintenance Manual

CHAPTER 2 – INSTALLATION

Page 12 of 138 AERCO International, Inc.  100 Oritani Dr.  Blauvelt, NY 10913 OMM-0069_0E

PRI: 11/26/2013 Phone: 800-526-0288 SP-100

local building codes require additional clearances, these codes shall supersede AERCO’s

recommendations.

 Sides: 24 in. (61 cm)

 Front: 24 in. (61 cm)

 Rear: 24 in. (61 cm)

 Top: 12 in. (30.5 cm)

All water piping and electrical conduit must be arranged so that it does not interfere with the

removal of any SmartPlate Heater assemblies/parts or inhibit service or maintenance of the unit.

24"

12"

52"

49"

Figure 2-1. SmartPlate Water Heater Clearances

CAUTION

While packaged in the shipping container, the heater must be

move using a forklift or pallet jack. After unpacking, the heater

should be lifted and moved using the lifting tabs (single-wall

model), or frame cutouts (double-wall model) provided on the

heater. Alternately, a forklift or pallet jack may be used to move

the unit by inserting the tines through the cutouts in the heater

base (Figure 2-1). Refer to the information in the following

paragraph.

2.3.2 Setting the Unit

If anchoring the unit, refer to Appendix F for anchor locations. SmartPlate Single-Wall Models

contain two lifting tabs at the top of the frame assembly (Figure 2-2 a). Double-Wall Models

contain two round cutouts on the frame plate and two on the pressure plate of the heat

exchanger (Figure 2-2 b). Use these tabs or cutouts to lift and move the unit.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 137 138

No comments

Aerco SmartPlate User Manual Page 12